Revisions
This product may be modified without notice, when necessary, due to product improvements, modifications, or changes in specifications. If such modification is made, the manual will also be revised; see revision information.
DOCUMENTATION REVISION 24.10.0 Oct 29, 2024
Applicable to rc_visard NG firmware 24.10.x
Please read the operating manual in full and keep it with the product.
COPYRIGHT
This manual and the product it describes are protected by copyright. Unless permitted by German intellectual property and related rights legislation, any use and circulation of this content requires the prior consent of Roboception or the individual owner of the rights. This manual and the product it describes therefore, may not be reproduced in whole or in part, whether for sale or not, without prior written consent from Roboception.
Information provided in this document is believed to be accurate and reliable. However, Roboception assumes no responsibility for its use.
Differences may exist between the manual and the product if the product has been modified after the manual’s edition date. The information contained in this document is subject to change without notice.
Introduction¶
Indications in the manual
To prevent damage to the equipment and ensure the user’s safety, this manual indicates each precaution related to safety with Warning. Supplementary information is provided as a Note.
Warning
Warnings in this manual indicate procedures and actions that must be observed to avoid danger of injury to the operator/user, or damage to the equipment. Software-related warnings indicate procedures that must be observed to avoid malfunctions or unexpected behavior of the software.
Note
Notes are used in this manual to indicate supplementary relevant information.